LED Light Setup Guide

How to install your CleverSpa® LED lighting®

Fit the LED lights loosely to allow the CleverSpa® to expand when filled.

Correct installation of your LED lights is extremely important. Failure to follow instructions carefully
may result in failure.

Ensure lights are not installed too tightly. They must be fitted loosely, with the freedom to move between the retention loops on the base of the hot tub.

Allow for some excess LED strip across each gap, this will reduce stress on the lighting. This allows the lighting strip to expand when filled with water.

Failure to do this can reduce the lifespan of your lighting - please see FIG 1 below.

Initial lighting setup

1. Connect the lighting system as shown in FIG 1.
2. Remove the plastic tape from the battery compartment
on the remote.
3. Turn the lights on with the power button.